FAQ and troubleshooting 39
target display to the Notebook
again.
system reboot, connect the Notebook to a standard VGA
• Connect the VGA cable to the Notebook and reboot the
When I connect the Notebook to an external monitor, the
the Notebook or to use simultaneous display.
e Notebook is being supplied
• If it blinks in white, the Notebook has entered Sleep mode in
is being supplied to the Notebook.
Connect the power adapter and restart the Notebook.
Should I drain the battery of my Notebook every time before
No. Your Notebook comes with an Lithium-ion (Li-ion)
power. The Notebook is configured to use the power saving
This is the default setting of the Notebook to conserve battery
Why does my Notebook seem to turn off itself after a certain
vents. For example, do not use the Notebook in bed where a
blanket may inadvertently cover the vents and block the airflow.
period of inactivity?
feature. You can go to
Start
>
Control Panel
>
Mobile PC
>
Power Options
to select your preferred power plan.
charging to retain its capacity?
battery pack. This is one of the newest cell types available. It is
also the lightest battery type currently available on a commercial
basis and can provide more power than other main cell types.
There are no known problems of memory effect with this
battery type and it is the easiest battery type to be maintained.
Display
There is nothing visible on the screen.
Check the Power button indicator.
• If it is not lit up, no power
order to conserve power. You can press the Power button to
resume from Sleep mode.
• If it lights up in white, th
normally with power. There are two possible causes for the
problem.
• The screen's brightness may have been set too low. Use
the <Fn> + <F6> hotkey combination to increase the
brightness.
• The display may have been switched to use an
connected external display device. Use the <Fn> +
<F7> hotkey combination to switch the display back to
display is abnormal.
The instructions below will guide you through the
troubleshooting process.
• Use the <Fn> + <F7> function key combination to make
external video signal enabled.
• Refer to the user manual that came with the external monitor
to check the settings.
system. If there is no display on the external monitor after
monitor, and wait until you can see things properly on that
VGA monitor. Then, connect the