3.
Install the protective cover on the bar, inserting it between the bracket and the
housing as shown below and fix it with four screws (Fig. 4).
4.
Connect top and bottom so that the bottom spring button fits into the hole in the
top bar. If necessary, turn the coil shaft so that the drive shaft located at the
bottom of the rod engages with the counterpart at the top. Secure the connection
with the clamping screw of the rod.
5.
Install the rod assembly to the engine using four screws (Fig. 5).
Nut
Washer
Mounting cup
Fig. 5
Fig. 4
