5.
Turn the ignition switch, located on the control handle, to the on/1 position.
Pressing the fuse lever, push the throttle lever (throttle lever) and lock it in the
depressed state using the lock (Fig. 10).
6.
Holding the trimmer, gently pull the starter handle until it engages in the starter
mechanism. Then vigorously pull the cord 50-60cm (Fig. 11). To avoid damage to
the starter case, do not drop the starter handle, gently return it to its original
position. Repeat these steps 3-5 times before the first flash of fuel in the engine. In
this case, the engine should not start.
7.
Move the choke lever (Fig. 9) to the middle position.
8.
Gently pull the starter handle until it snaps into the mechanism and vigorously pull
the cord another 50-60cm. To avoid damage to the starter case, do not throw the
starter handle; gently return it to its original position. Repeat these steps 2-3 times
and the engine should start.
9.
Immediately after starting the engine, slightly push the throttle control lever and
release it. The engine should go to idle mode. Move the air flap control lever to the
lower position (open).
Fig. 11
Fig. 10
Gas throttle
lever
Gas throttle
trigger
Gas throttle
lock
Switch
