Step 3:
Insert the front wheel assembly
(C)
through the tube on the front bike frame
(A)
. The
top of the front wheel assembly
(C)
should protrude out slightly.
Step 4:
Using the Allen key/Phillips head screwdriver
(E)
, loosen and remove the screw and
nut from the handlebar
(B)
. Insert the handlebar onto the protruding part of the front wheel
assembly
(C)
. The handlebar will then rest on top of the front bike frame
(A)
.
Align the two holes on the handlebar
with those on the front wheel assembly
(C)
, then using
the Allen key/Phillips head screwdriver
(E)
, reinsert and tighten the screw into one hole
whilst holding the nut on the other.
E
(x1)
Note:
Do not tighten the handlebar with a torque of more than 15Nm.
A
C
Nut
Screw
B
C
