4. Make sure the end of the hose is no higher than the spout, or
water could remain in the tank. Make sure there are no kinks
in the hose (Fig 6).
NOTE: Keep the rubber bung close to the spout.
Instructions for fitting castors
1. Unplug from the mains socket and empty the tank
(if full).
2. Remove the rubber caps from the bottom of the
appliance by pulling forcefully or using pliers (see
Fig 7/1).
3. Fit the castors by inserting the pins into the holes
(see Fig 7/2).
NOTE
: While fitting the castors, do not tilt the appliance at
an angle of more than 45°. After fitting the castors, wait
for at least an hour before using the dehumidifier again.
How to Dehumidify
Description of buttons
ON/Standby
: toggles the unit between running and standby mode.
MODE
: selects operating modes between dehumidifying, dry, smart and fan.
FAN
: selects fan speed.
Hygrometer/thermometer
: Temporarily displays the temperature and humidity
measured in the room by the appliance. Measurements displayed are indicative only.
Humidity increase/decrease
: Adjusts the percentage of humidity present in the room,
increasing or reducing it by steps of 5%.
5
Display
Hygrometer /
thermometer button
ON/Standby button
Fan button
Decrease
humidity
button
Increase
humidity
button
MODE button
Summary of Contents for KADHM16LXXA
Page 1: ......
