Installing the Batteries
•
Remove the emergency lock cover and unlock the safe using the emergency key.
•
Pull the door open.
•
Remove the battery compartment cover.
•
Insert x4 AA batteries into the battery compartment. Pay close attention to the
orientation of the polarity symbols (+ and -).
Setting the Passcode
By default the factory passcode is “159”. It is highly recommended to change the passcode
to something more secure.
•
Open the door and press the reset button, the yellow indicator will flash and the
safe will beep.
•
Input a new code (between 3-8 digits) and press “#” to confirm. If the code change
has been successful, the yellow indicator will flash twice and the safe will emit 2
beeps.
•
If the yellow light flashes 3 times with 3 beeps, the code change has failed and the
process will need to be repeated.
Unlocking the Safe
Passcode:
1.
Input the passcode and press the “#” button to confirm.
2.
The yellow indicator will flash twice, the safe will emit 2 beeps and the green
indicator will turn on.
3.
The safe has been successfully unlocked. Turn the knob clockwise to open the safe.
OPERATION
Note:
If the red indicator turns on during operation, the batteries are low and will need to be
replaced. It is highly recommended to use a high-powered alkaline battery.
