Water Purifier
The service life of the water purifier element is 3000 litres of tap water.
Installation
Wash your hands thoroughly before handling the various elements.
1. Take the ceramic filter and multi-layer cartridge and place them in a clean bucket of
water and allow to soak for at least 30 minutes, then rinse them both thoroughly.
2. Wash the lower tank thoroughly.
3. Place the joining ring onto the top of the lower tank.
4. Take the multi-layer cartridge and screw it into the seating/holder, taking care not to
overtighten it.
5. Place the assembled cartridge onto the joining right properly.
6. Take the upper tank and insert the plastic filter. The washer must be on the inside. Once
again, do not overtighten.
7. Place the top tank on to the joining ring.
8. Place the floating valve onto the bottom of the lower tank.
9. Remove the smart seat of the dispenser and place the unit onto the dispenser.
10. Check all parts for secure fitness and alignment.
11. Fill tank with water, then place the top cover in place.
Filter Maintenance
1. Remove the top lid.
2. Remove the top filter cover, wash or replace the filter
cloth (as shown to right)
3. The filter element itself can be unscrewed
counterclockwise.
Notes
•
Black activated carbon powder will float in the water when the filter is first used. Clean
the water filter and let this black water flow out before putting the filter onto the
dispenser.
•
The water purifier must be located out of direct sunlight.
•
Water being fed through the filter should be clean tapwater. Do not put grey water or
other dirty water through the filter as this will greatly reduce the lifespan of the filter.
•
If you find that the speed of filtration after 200-300 litres is still slow, please take out
the top layer of the filter element and wash it under a fast flowing tap.
•
Please change the filter after one year's use or after 3000 litres of water filtration.
