7
Cautions:
1.
The ceramic cooktop must be installed by qualified personnel or technicians. Please
never conduct the installation by yourself.
2.
The ceramic cooktop shall not be mounted to cooling equipment, dishwashers and
rotary dryers.
3.
The ceramic cooktop shall be installed such that better heat radiation can be ensured
to enhance its reliability.
4.
The wall and induced heating zone above the work surface should withstand heat.
5.
To avoid any damage, the adhesive must be resistant to heat.
6.
A steam cleaner is not to be used.
Connecting the Hob to the Mains Power Supply
The power supply should be connected in compliance with the relevant standard or a single-
pole circuit breaker. The method of connection is shown below.
1.
If the cable is damaged or needs replacement, this should be done by a qualified
technician using the proper tools, to avoid any accidents.
2.
If the appliance is being connected directly to the mains supply, an omnipolar circuit
breaker must be installed with a minimum gap of 3mm between the contacts.
3.
The installer must ensure that the correct electrical connection has been made and
that it complies with safety regulations.
4.
The cable must not be bent or compressed.
5.
The cable must be checked regularly and only replaced by a properly qualified person.
The bottom surface and the power cord of the hob are not accessible after installation.
