Step 3:
•
Connect two screen tubes
(D)
with one vertical connector to form a short pole
assembly. Repeat this process again so you have two screen pole assemblies.
•
Slot the screen pole assemblies through either side of the projector screen and
connect them with the 3-way connectors placed in step 1.
Step 4:
•
Form another long pole assembly as instructed in step 2.
•
Slot the long pole assembly through the top edge of the projector screen.
•
Place one bend connector
(H)
on each end of the long pole assembly and connect
the bend connectors with the top ends of the screen pole assemblies slotted in step
3.
x2
Summary of Contents for KAPRS100WA
