•
Clean toaster before using it for the first time (see page 7 for cleaning
instructions).
•
Place the toaster on an even and heat-resistant surface. Do not place the
toaster where heat, moisture or high humidity are generated, or near
combustible materials.
•
Plug the toaster into an appropriate power outlet and switch on power at
the outlet. The power socket must be readily accessible so that in an
emergency it can be easily switched off and the toaster unplugged.
•
Set the browning control to the maximum level (6) and press the on/off
button.
•
Let your toaster heat up for approximately four minutes without any bread.
NOTE: Due to remnants from the manufacturing process burning off, you
may notice a slight burning smell when first using the toaster. This is no
cause for concern. Place the toaster in a well ventilated area and let it
complete a few toasting cycles until no more odour or smoke is present.
•
After a short cooling down period, your toaster is now ready for use. The
usage instructions start just below. All parts referred to in the instructions
are listed on page 4.
Toasting
•
Make sure the crumb tray is properly in place before using the toaster. (It is
located underneath the heating elements and can be pulled out from the
side of the toaster opposite the controls.)
•
Make sure that the power cord underneath the
appliance is clamped in the respective cable guide:
there are two guides for the cord exit, one for a 120V
flat cord and one for a 240V round cord (as pictured,
right).
•
Place the toaster on an even and heat-resistant surface and connect it to a
properly installed wall socket. The LCD panel lights up and displays the
chosen settings (browning level, countdown time, special functions, etc.).
•
Press the open/close lid button to open the lid.
•
Insert the bread into the bread slots. The toaster holds two slices.
•
Turn the browning control knob to your desired browning level (1 - 6). The
higher the number, the longer the toasting time. (See page 6 for hints on
toasting times for different types of bread.)
•
Press the on/off button. The lid of the toaster closes automatically and the
toasting process starts. The LCD panel will display the countdown toasting
time.
•
When the required toasting level has been achieved, the toaster switches
off automatically. The lid opens, moving and lifting the toast slices into their
initial position for easy removal.
NOTE:
To interrupt the toasting cycle before automatic cut-off, press the
on/off button. The lid will open and the toast slices can be removed.
•
After several toasting cycles, pull out the crumb tray and clean it. (See the
cleaning instructions on page 7.)
WARNING:
If a slice of bread should get stuck during the toasting process,
unplug the appliance and let it cool down completely before trying to remove it.
Do not use any sharp metal objects to do so.
5
Summary of Contents for KASMT02TSTA
Page 1: ......
