2
Safety & Warnings
Safety Information
•
This appliance is a high-power blender.Please use a separate high-power outlet(>5A) of
high quality. Do not share the outlet with an air conditioner,induction cooker or other
high-power appliance to avoid a fire caused by overcurrent.
•
This blender is a Class-I electrical appliance. For the sake of your safety, please ensure
the availability of a good grounding circuit during use of the blender.
•
When hot water is used or the work bowl is fully filled,do not exceed the highestscale
mark.
•
Make sure the work bowl cover is tightly closed andgradually turn the
“
Speed Control
Switch
”
from low to high speed.After operation,take out the processed food carefully to
avoid burns.
•
Do not use the work bowl if it is broken or chipped. Check to see if the rotating unit and
the blade are loosened or damaged. When the work bowl has been used for one year or
longer, it is suggested to replace it with an original one of the same specifications.
•
When the appliance is running, never use your hand or any other part of your body to
touch the rotating unit, especially the blade. Take care when cleaning or replacing the
blade to avoid cuts and other dangers.
•
Do not rinse the appliance directly withwater.Take care not to allow water, soup or any
other liquid to splash into the appliance.
•
Do not place the appliance near a gas stove, kerosene stove or gas burner or in an
environment with naked fire or high temperature.
•
To avoid possible dangers, ensure only responsible adults of sound mind use the
appliance. Do not allow children or the elderly to use the unit due to increased risk of
injury.
•
Do not use the appliance on a carpet, tablecloth or thin paper to avoid blocking the air
suction and exhaust ports, which may affect heat dissipation inside the appliance.
•
In order to avoid damage, start the appliance when there is no food in thework bowl.
•
During use, take care to protect the appliance from insects, dust and moisture and avoid
short circuiting the unit. If the appliance is to be left unused for a long period,it is
suggested to store it in a plastic bag after cleaning.
•
Prior to operation, the unit should stayabout 20cm away from the appliance. To process
liquid food, the appliance must be started at slow speed since impact can be caused by
instant start, which may result in liquid splashing out of the container.
•
Put prepared food into the work bowl. The food volume should not exceed the safe scale
mark on the work bowl. Then tightly close the work bowl cover.
•
The work bowl uses an open design. When food processing is finished, take out the
processed food as early as possible. If it is impossible to take out it immediately, there
might be slight water seepage at the bottom of the work bowl, which is a normal
phenomenon. Please take out the processed food immediately and clean the work bowl.
•
Prior to starting; first confirm that thework bowlis fully connected with thepower
base,and that therubber coveris fully connected with thework bowl. In order to avoid
overflow of food, do not open the work bowl cover during use.
•
After use, disconnect the power plug from the outlet to avoid damage to the electronic
components or even caused by long-time conduction.
•
If the blender is to be left unused, remember to unplug it from the power outlet.
•
Do not open the work bowl cover until the stirring blade comes to a full stop.
•
For cleaning, first confirm that the power plug has been disconnected and then separate
the power base from the container.
•
Never soak the motor base in water or clean it in a dishwasher.
