Step 2:
Concrete and masonry walls
Use a spirit level to double check the correct angle of the mount and mark the intended hole
positions with a pencil (
2b
). Drill holes in the desired locations (95mm deep, 12mm wide) (
2b
).
Insert the screw anchors (W-B) into each pre-drilled hole, then insert the top screw (W-A) first
to support the mount (
2c
). With the wall mount held in place, insert the washers and screws
(W-C, W-A), tightening with a socket wrench (
2d
).
A minimum of two people are recommended for this installation. Failure
to use safety gear and safe working methods may result in property
damage, serious injury, or death.
Summary of Contents for KAWLM70TLTA
