22
2.
Using the insulating tape wrap the refrigerant pipes, connecting wires and
drainage hose together tightly.
Step 8: Mount Indoor Unit
1.
Slowly pass the refrigerant pipes, connecting wires and drainage hose wrapped
bundle through the wall hole.
2.
Hook the top of the indoor unit on the mounting plate.
3.
Apply slight pressure to the left and right sides of the indoor unit, make sure the
indoor unit is hooked firmly.
4.
Push down the bottom of indoor unit to let the snaps onto the hooks of the
mounting plate and make sure it is hooked firmly.
If the refrigerant pipes were already embedded in the wall or if you want to be
connecting the pipes and wires on the wall, do as below:
1.
Gab both ends of the bottom plate, apply a little outward force to take off the bottom
plate.
2.
Hook the top of the indoor unit on the mounting plate without piping and wiring.
3.
Lift the indoor unit opposite the wall, unfold the bracket on the mounting plate and
use this bracket to prop up the indoor unit, there will be a big space for operation.
4.
Do the refrigerant piping, wiring, connect drainage hose and wrap them as Step 4 to 7.
5.
Replace the bracket of mounting plate.
6.
Push down the bottom of the indoor unit it snaps onto the bottom hooks of the
mounting plate and ensure it is hooked firmly.
7.
Replace the bottom plate of the indoor unit.
Unfold the bracket on the mounting plate
Take off the bottom plate
Summary of Contents for SMARTERHOME KASHSAC80TA
Page 1: ...KOGAN SMARTERHOMETM INVERTER SPLIT SYSTEM 8 2KW REVERSE CYCLE AIR CONDITIONER KASHSAC80TA...
Page 65: ...65 NOTES...
Page 66: ...66...
Page 67: ...67...
