3.1.1
Place a single, thin, even layer of vermiculite into the burner tray as
3.1
FITTING THE FUEL-BED LOGSET
3.1.1
Place a single, thin, even layer of vermiculite into the burner tray as
shown below in figure 10.
Ensure that the layer of vermiculite is
evenly distributed in the fuel-bed tray. Remove any vermiculite
from the pilot aperture as indicated by the arrows in figure 11.
The burner can be removed if necessary so any vermiculite can be
removed from below the burner tray. DO NOT USE
BOTH NATURAL AND BLACK VERMICULITE SUPPLIED TOGETHER,
SELECT AND USE ONLY THE PREFERRED OPTION.
Fig. 11
3.1.2
Place log “A” onto the rear left hand side of the fuel-bed tray as shown
below in figure 12, using the locating pins as indicated above in figure
11 to ensure correct placement. Place a layer of “embaglow” material
as required.
Fig. 12
17
Locating pins for Log “A”, see section 3.1.2
Log “A”
