5
1418436-T01-A
注意：
1.
请用户自备角阀。
2.
请勿将进水口与出水混淆。
3.
进水软管处的滤网组件
(45)
和接头
(46)
不要漏装(滤网方向如图)。
4.
在软管
(43)
连接控制阀组件前，先
将角阀完全打开，通水约一分钟以
清除管道杂质。
取出电池盒组件，拧开螺钉
(47)
，按
电池盒盖
(48)
上的正负极标示分别装
入
2
节
5
号电池
(49)
，锁紧电池盒盖
(48)
的螺钉
(47)
后，将电池盒组件放
入阀盒的专用槽内。
注意：
电池正负极不能装反，新旧电池不
能混用。
48
49
50
51
47
注意：
在用螺钉
(30)
固定阀盒
(28)
和阀盖
(29)
时，确保探头线
(40)
需通过阀盖
上
U
型缺口。
30
40
28
29
最后，将电磁阀上的红绿线与对应
探头组件上的红绿线接插，将电池
盒黑橙线与主探头组件上黑橙线接
插，再用阀盒盖螺钉
(30)
拧紧阀盒
(28)
和阀盖
(29)
。
Note:
1. Customer shall provide angle valve.
2. Do not confuse water inlet with outlet.
3. No leak strainer assembly (45) and
connector (46) on flex water inlet hose. (Filet
direction as shown)
4. Before connect flex hose (43) to control
valve assembly, turn on angle valve to fully
open, allow water to run through the spout
for about 1 minute to remove debris.
Remove battery box assembly, unscrew
screws (47), and install two AA batteries (49)
per +/- mark direction on the battery box
covers (48) and then secure battery box
cover (48) and screws (47). Place battery
box assembly into the groove designed for
valve box.
At last, connect red/green wire on the
solenoid valve to corresponding wire on
probe assembly, black/orange wire on
battery box to corresponding wire on main
probe assembly, then secure valve box (28)
and valve cover (29) by cover screws (30).
Note:
Do not install b/- polarity reversely;
do not mix new and old batteries.
Note:
When secure valve box (28) and valve cover
(28) by screws (30), make sure probe wire
(40) shall cross through the U slot on valve
cover.
28
29
30
电磁阀
电池盒
solenoid valve
battery box
43
进水口
出水口
46
45
9
滤网组件
Filter Assy
Water outlet
Water inlet
