-8-
NOTE:
After the filter is replaced, the corresponding button
can be reset only. If not, the filter life indicator can't be
accurate. No need to reset after the first installation.
NOTE:
Filtration performance varies depending on local
water quality.
Step 3: Installing Filter Cartridge & Replacing Filter
Cartridges
Fig.#9
9
Remove and discard the dustproof cap (sanitary
protective cap) from the cartridge;
Push the filter cartridge into the filter base align the hollow
icon of the cartridge with the hollow icon on the filter base,
then turn cartridge clockwise until the hollow icon of the
cartridge were aligned the color filled icon on the filter
base, it will be fully installed. (Figure 9)
90
( 9)
Fig.#10
10
When filters replaced remember to push and hold the
corresponding reset button to the filter for 5 seconds until
the indicator automatically with 2 short beep, then
corresponding orange LED light turn to white. (Figure 10)
Please replace filter when prompted by the indicator.
5
( 10)
System Model
First Stage
Second Stage
Third Stage
Press
filter button for
5 seconds to reset
K-30843T-KPT40-01R
K-30843T-KPP40-01R
K-30843T-KPQ40-C10
K-30844T-R1-01R
K-30844T-R2-01R
K-30844T-R3-01R
BEFORE
AFTER
滤芯安装前
滤芯安装后
/
LED white: Filter is in regular service
白色：滤芯可正常使用
LED turn to red：Filter life is running low (replace filter one month later)
红色常亮： 滤芯预警（约1个月左右需要更换）
LED turn to red blinks：Filter life is running out
红色闪烁： 滤芯报警（建议立刻更换该滤芯）
长按该滤芯按键5秒重置滤芯寿命
1406034-T01-D
注意：滤芯的点应朝上对齐，不可朝下安装
