Product Information
Applicable product:
Bath with airjets
K-1110-G
Bath with airjets and chromatherapy
K-1110-GCR
Fixture*:
Bathing well:
Basin area, bottom
45
″
(114.3 cm) x 25-1/2
″
(64.8 cm)
Basin area, top
63
″
(160 cm) x 31-1/2
″
(80 cm)
Weight
134 lbs (60.8 kg)
To overflow:
Water depth
21
″
(53.3 cm)
Capacity
115 gal (435.3 L)
* Approximate measurements for comparison only.
Included components:
Cut-out template (for drop-in installations only) 1016369-7
Blower motor/
control:
Heater
V
Hz
A
300 W
220-240 V
50/60
3
Required accessories:
Undermount template kit (for undermount
installations only)
K-589
Bath drain
K-7202
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Blower motor/control:
220-240 V, 15 A, 50/60 Hz
Notes
Install this product according to the installation guide.
NOTICE: If the blower motor and check valve are relocated, the
following two procedures are required: 1.
Provide two access
panels. Locate one access panel at the blower motor/control
location and the other access panel at the control box.
2.
Relocate
the blower motor and the check valve together. Do not relocate one
without the other.
Floor support under bath must provide for a minimum of 47 lbs
(228 kg).
Hot water supply should be 70% of capacity or greater.
Installations will vary.
This bath is designed for drop-in or undermount installation only.
It is not suited for use in a three-wall alcove with an overhead
shower.
Fixture dimensions are nominal and conform to tolerances in ANSI
Standard Z124.1.2.
Blower/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
23"
(58.4 cm)
24-1/2"
(62.2 cm)
25-11/16"
(65.2 cm)
6-1/2"
(16.5 cm)
46"
(116.8 cm)
6"
(15.2 cm)
5-1/2"
(14 cm)
1-3/8"
(3.5 cm)
1-3/16"
(3 cm)
12-3/16"
(31 cm)
3-15/16"
(10 cm)
3-3/8" (8.6 cm)
72" (182.9 cm)
4" (10.2 cm)
6" (15.2 cm)
7/16" (1.1 cm)
1-1/2" OD
No change in measurements with drain
shown. (K-7202)
K-1110-GCR
1038266-1-C
2
Kohler Co.
