Operation
NOTE:
Please read these steps carefully before operating your whirlpool.
NOTE:
The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.
Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
Close the drain and fill the bath above the backjet level probes.
Place your hand in the bath to test the water temperature for comfort and safety, then carefully
enter the bath.
Press the power icon. The heater will turn on and the whirlpool will start at a medium water flow
volume. The chromatherapy cycle icon will illuminate on the keypad and three small lights near the
whirlpool floor will illuminate until the keypad goes into sleep mode.
Press the up or down arrow to increase or decrease the water flow volume. The indicator bar in the
center of the keypad will display the current water flow volume.
Rotate the jet trim clockwise to reduce the air/water flow or counterclockwise to increase the
air/water flow.
Position the Flexjet nozzles to direct the water flow to maximize your hydro-massage experience.
Rotate the outer ring until the heater mode is flashing, then press OK. The heater will turn off. Press
OK again to turn the heater back on.
NOTE:
In backjet mode, if the water level is lower than the backjet level probes, this mode will stop. The
backjet icon and indicator bar on the user keypad will flash. The backjet mode will automatically restart
when the water level reaches the backjet level probes.
Rotate the outer ring until the backjet mode is flashing, then press OK. Press the up or down arrow
to increase or decrease the pulsing action. Rotate the outer ring to the Flexjet mode, press OK to
activate the mode, then press the up or down arrow on the keypad to increase or decrease water
flow to the backjets and all other active modes.
Rotate the outer ring until the chromatherapy cycle is flashing, then press OK to activate it. Press
OK while the chromatherapy mode is active to turn off this mode.
Rotate the outer ring to the chromatherapy specific color. When flashing, press OK to activate it.
Press the up or down arrow to reach the desired color, then press OK to activate the desired color.
Press the power icon to turn the whirlpool off. The three small lights near the whirlpool floor will
remain illuminated until the keypad goes into sleep mode.
Turn the Flexjet
trim clockwise to
decrease the flow.
Turn the Flexjet trim
counterclockwise to
increase the flow.
Position the jet nozzles
to direct the water flow
as desired.
Fill with water until the backjet level
probes are covered with water.
Level
Probes
1042760-5-D
6
Kohler Co.
