Product Information
Applicable product:
Integral apron, heater, left drain
K-1112-HL
Integral apron, heater, right drain
K-1112-HR
Fixture*:
Bathing well:
Basin area, bottom
43
″
(109.2 cm) x 20-1/2
″
(52.1 cm)
Basin area, top
53-1/2
″
(135.9 cm) x 32-1/8
″
(81.6 cm)
Weight
120 lbs (55 kg)
To overflow:
Water depth
15
″
(38.1 cm)
Capacity
57 gal (215.9 L)
* Approximate measurements for comparison only.
V
Hz
A
Pump: 1-speed
120
60
7.5
Heater: 1.5 kW
120
60
12.5
Required Electrical Service (2 required)
Two dedicated circuits required, each protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
120 V, 15 A, 60 Hz
Heater
120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24
″
(61 cm)
of the pump and heater.
Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
36 lbs/square foot (173 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
This fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
1-1/2" OD
10-13/16" (27.5 cm)
60" (152.4 cm)
42" (106.7 cm)
3/8" (1 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Recommended faucet area
21" (53.3 cm)
1-1/4" (3.2 cm)
Tile Flange
Detail
1-1/4"
(3.2 cm)
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
21"
(53.3 cm)
3-1/8"
(7.9 cm)
1-1/4"
(3.2 cm)
3-1/2"
(8.9 cm)
1047170-1-D
2
Kohler Co.
