Kohler Co.
5
1112748-X2-B
ตำาแหน่งเครื่องเป่าลม หรือดัดแปลงใดๆ กับระบบและชุดอุปกรณ์ต่างๆ ซึ่งอาจมีผลกับ
ประสิทธิภาพและความปลอดภัยในการใช้งานระบบนำ้าวนอัดอากาศ โคห์เลอร์ (ประเทศไทย)
จะไม่รับผิดชอบต่อการกระทำาดังกล่าว รวมถึงการได้รับบาดเจ็บและความเสียหายต่างๆ ที่อาจ
เกิดขึ้นจากการไม่อนุญาตให้ทำาการดัดแปลงสุขภัณฑ์
Product Requirement
A. Summary Of Key Requirements
¨
Observe all local plumbing codes.
¨
Install the unit to a level subfloor.
B. Plumbing Specifications
If installing a rim-mount faucet, make sure there is no interference with drain
overflow before drilling any holes.
Confirm adequate mounting and connection space for the faucet specified for
your installation.
C. Product Inspection
Unpack and inspect bath for damage. All Kohler’s baths have been manufactured
with sophisticated craftsmanship. However, please inspect for any possible
damage that may have occurred in transit. Leave all materials in the crate
during construction to prevent damage.
NOTE:
Damage occurred during transit shall not be covered by warranty.
D. Electrical Requirements
The installation must have a Class A Ground-Fault Circuit-Interrupter (GFCI).
The GFCI protects against Line-to-ground shock hazard. Use a 220-240 V, 10 A
(minimum), 50 Hz dedicated service for the bath with airjets.
E. New or Replacement Installation Requirements
This bath can be installed in new or existing bathrooms.
For replacement: Remove the old bath, and remove enough old wall material
and floor covering from the area to allow for installation. Remove any old
plumbing that does not conform to the rough-in requirements.
For new installation: Position the plumbing according to the roughing-in
dimensions.
F. Clearance Requirements
¨
Check the rough-in and room dimensions to provide adequate available
space for the bath unit.
¨
Make sure the flooring offers adequate support for your bath, and verify
that the subfloor is flat and level.
Summary of Contents for K-11344X-G
Page 23: ...Kohler Co 23 1112748 X2 B ...
