1023249-5-
A
5
Kohler Co.
Lighted User Keypad
Chromatherapy
Cycle
Power
On/Off
Flexjet
Flow Mode
Activates
Mode Selected
Increases
Flow or Pulse
Neckjet Mode-
Adjust Pulse
Indicator Bar- Shows
water flow volume or
pulse speed
Decreases
Flow or Pulse
Backjet Mode-
Adjust Pulse
Effervescence
Mode
Heater
On/Off
Chromatherapy-
Specific Color
NOTE
: Keypad above shows all
features available. Your keypad may
vary based on your whirlpool model.
Rotate outer
ring to access
desired mode
User Keypad and Whirlpool Modes/Features
S
Power-
Turns the whirlpool pump on and off. Symbols illuminated in blue indicate available modes/features.
Modes which are operating will display in green.
S
Outer Ring-
Rotate the outer ring to the desired mode. The selected mode will flash (blue).
S
Activate Button-
Press “OK” to activate the desired mode. The active mode will flash (green).
S
Up Arrow-
Increases the water flow when the Flexjet mode is active. Increases the pulse speed when the neckjet
or backjet mode is active.
S
Down Arrow-
Decreases the water flow when the Flexjet mode is active. Decreases the pulse speed when the
neckjet or backjet mode is active.
S
Flexjet Mode-
When active, this mode allows you to adjust the water flow by pressing the up or down arrows.
S
Neckjet Mode-
When active, the neckjets are operating and you may adjust the pulsing speed by pressing the up
or down arrows.
S
Backjet Mode-
When active, the backjets are operating and you may adjust the pulsing speed by pressing the up
or down arrows.
S
Effervescence Mode-
Effervescence ports activate to provide a gentle, soothing bubbling action. The Flexjet
mode, backjets and neckjets will automatically turn off when the effervescence mode is activated.
S
Chromatherapy Cycle-
Chromatherapy lights will automatically and continuously cycle through the eight colors;
white, violet, indigo blue, aqua blue, green, yellow, orange and red. One cycle through all eight colors takes
approximately one minute.
S
Chromatherapy Specific Color Selection-
When this mode is selected, you may choose a specific color for the
bath.
S
Heater-
The heater automatically engages when the whirlpool is turned on. To turn the heater off, rotate the outer
ring until the heater mode is flashing and press “OK”. Press “OK” again to turn the heater back on. The heater
will help to maintain the water temperature up to 104
_
F (40
_
C).
S
Indicator Bar-
Shows the water flow volume in the Flexjet mode. Shows the pulse speed in the neckjet or backjet
mode.
