1022231-5-
A
6
Kohler Co.
Care and Cleaning Instructions
Cleaning Your Acrylic Bath Whirlpool
-
Do not
use abrasive cleansers or solvents on acrylic surfaces.
-
Wipe out your acrylic whirlpool with a soft cloth after each use.
-
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
-
If the surface gets excessively dirty you can use a general purpose cleaner such as: Formula 409
r
All Purpose
Cleaner, Gel Gloss
r
(Bath and Shower only), Scrub Free
r
Mildew Stain Remover, Mr. Clean Lemon Fresh, Cinch
r
,
Glass Plus
r
, or Fantastik
r
All Purpose.
To restore dull or scratched units: Apply white automotive polishing compound with a clean rag. Rub scratches
and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax. Do not wax areas
where you walk or stand.
Cleaning Your User Keypad and Remote Control
-
Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty, use a
non-abrasive soap and warm water to clean.
Flushing Your Whirlpool System
Flush your whirlpool system twice a month or more, depending upon usage. Use the following sequence:
-
Turn the jet trim rings fully clockwise to remove air induction.
-
Fill the whirlpool with warm water to a level at least 2” (5cm) above the highest jets, or leave water in the
whirlpool after using.
-
Add 2 tablespoons (30 ml) of a low-foaming dishwasher detergent and 20 ounces (590 ml) of household bleach
(5% - 6% sodium hypochlorite) to the water.
-
Run the whirlpool for 5 to 10 minutes. Turn off the whirlpool and drain.
-
If desired, rinse the bath surfaces with water.
-
Rinse the surfaces of the jets, faucet, handrails, drain, etc. and wipe them dry with a soft cloth.
