Product Information
Applicable product:
5.5’ Vibracoustic bath
K-1822-VB
5.5’ Vibracoustic bath with chromatherapy
(shown)
K-1822-VBC
Fixture*:
Bathing well:
Basin area,
bottom
44-1/2
″
(1130 mm) x 22-5/16
″
(567 mm)
Basin area, top
59-5/8
″
(1514 mm) x 25-1/2
″
(648 mm)
Weight
91 lbs (41.3 kg)
To overflow:
Water depth
18
″
(457 mm)
Capacity
85.8 gal (325 L)
* Approximate measurements for comparison only.
Drop-in cut-out
64-1/2
″
(1638 mm) x 30-1/2
″
(775 mm)
Amplifier/
control:
Power per channel (rms) W
V
Hz
15
120
50/60
Required accessories:
Slotted overflow brass bath drain
OR
K-7271
Slotted overflow bath drain – PVC pipe
K-7272
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Amplifier/control
120 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
The bath is intended for drop-in installation.
Control amplifier fits 16
″
(406 mm) center studs.
A grounded outlet within the wall framing must be within 24
″
(610
mm) of the planned control amplifier.
Cables are included, 25’ (7.6 m) each.
Four access panels are required for servicing the bath.
Floor support under bath must provide for a minimum of 56.7
lbs/square foot (277 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions are
nominal.
1"
(25 mm)
66" (1676 mm)
22"
(559 mm)
32"
(813 mm)
2-7/16"
(62 mm)
16"
(406 mm)
2"
(51 mm)
16-3/4" (425 mm)
13/16"
(21 mm)
4-1/8"
(105 mm)
No change in measurement if connected with
drain illustrated. (K-7272)
1-1/2" Bath Drain
*10"
(254 mm)
*24"
(610 mm)
Lumbar
Angle 40˚
*Recommended User
Interface Location
5-5/8"
(143 mm)
3-1/2"
(89 mm)
7/8"
(22 mm)
User Interface
Control Amplifier
14-1/2"
(368 mm)
11-3/4"
(298 mm)
3-3/16"
(81 mm)
Access Panels
30" (762 mm) L x
15" (381 mm) H Min
Access Panels
30" (762 mm) L x 15" (381 mm) H Min
1188023-1-A
2
Kohler Co.
