4
INSTALL BATH
1)
1) Your new Hydrotherapy Massage Spa has been
manufactured to the highest possible standards, it has
been factory tested and approved.
2a) Locate bath in proposed position.
The protective film originally covering your whirlpool
has been removed to fit its equipment, therefore,
carefully protect its surface during installation.
2a)
1305
700
1305
1419
2b)
: Whirlpool must be installed level on
all top edges.
2b)
IMPORTANT
1036303-T01-B
3)
A.
3) Fit timber batten supports or check into wall where
necessary. See diagrams below for typical installation
with tiled walls.
Floor should be flat, level and free of any bumps and
protrusions. Ensure support feet are fully supported.
A. Base Support
Brick
Support Wall
Bath Rim MUST Be Supported
Bricks allow access to waste fitting