2. Install the Lavatory
CAUTION: Risk of personal injury.
Vitreous china is heavy. Do
not attempt to lift or install this product without assistance.
Apply two self-adhesive pads to the underside of the lavatory
basin.
Mark the centerline of the pedestal on the floor with a pencil.
Align the center of the pedestal on the marked centerline.
Place the lavatory onto the pedestal.
Verify the lavatory is level and flush against the finished wall.
Adjust or add self-adhesive pads as needed.
NOTE:
If the bottom of the lavatory contacts the pedestal, reposition
the self-adhesive pads.
Mark the two lavatory anchoring hole locations on the finished
wall with a pencil.
Mark the pedestal anchoring hole on the floor through the hole in
the pedestal bottom.
Remove the lavatory from the pedestal. Set the lavatory aside.
Set the pedestal aside.
Drill 3/16
″
holes at the marked locations on the finished wall and
the floor.
Install the hanger bolts to the wood backing material.
Thread the cap nuts onto the hanger bolts.
Apply two self-adhesive
pads to the underside of
the basin.
Hanger Bolt
Washer
Cap Nuts
Lag Bolt
Washer
The drain and
faucet are not
shown to
improve clarity.
Pedestal
1020683-2-E
4
Kohler Co.
