1153043-X5-C
36
Kohler Co.
For best results, keep the following in mind when caring for your KOHLER product:
•
Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
•
Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and dry any
overspray that lands on nearby surfaces.
•
Do not allow cleaners to soak on surfaces.
•
Do not use scouring powder, abrasive powder or corrosive detergents (such as oily, acidic, alkaline etc.) to
clean the remote control.
•
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean
surfaces.
•
The instructions concerning persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge and children playing with the appliance are not applicable.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
For detailed cleaning information and products to consider, contact Call Center 0 2204 6222.
Troubleshooting Information
Care and Cleaning
NOTE:
When the remote control is not in use, it will fall into sleep mode. Press touch the remote control
screen to activate the remote control.
NOTE:
If the back light is off, the first touch on the remote control screen activates the light. The second touch
activates the function.
Start-up
¨
When the toilet is first installed or the power fails, when power is restored or turned on; the toilet will
automatically go into start-up mode.
¨
If the toilet does not function correctly upon completing the start-up sequence, or it fails to start, contact
customer service using the numbers located on back cover of this manual.
Blockage
¨
To clear the toilet when there is a blockage, a standard plunger* with an insert works best.
¨
If a blockage requires the use of a snake*, use the remote control to open the valve before using the snake.
Close the valve when the blockage is cleared.
Small Children
¨
The auto flush and bidet features require a sensor located under the seat to be activated. Small children may
not be tall enough (approximately 122cm) to activate the sensor. The bidet and autoflush features will not
function correctly when this sensor has not been activated.
*Plunger
*Snake
