P.Secure the Vitreous Shell
Fig.#24
Fig.#25
Toilet Back
Access Cover
Access
Opening
Caulk Base
Of Toilet.
O.Check Operation
Fig.#23
NOTE:
The flushing mechanism works best if it is quickly
tapped, not held down for an extended period of time.
NOTE:
There is an approximate eightsecond delay between
the flush and the tank refilling.
CAUTION: Risk of product damage.
Do not over-
tighten the screws when tightening. The vitreous shell
may chip or break if the screws are overtightened.
Flush the toilet and check for proper operation.
Refer to "Homeowner's Guide" to check whether the bidet
seat functions well.
Refer to the troubleshooting chart if the toilet does not func-
tion properly.
Insert a screw through both grommets.
Insert a screw in both of the provided holes and tighten. Do
not overtighten.
Place a cap over each screw. The caps should be flush with
the exterior of the shell.
Cut a recess in the access cover using a utility knife at the spot marked on the access cover.
Place the access cover over the opening in the back of the toilet.
Caulk around the base of toilet and caulk the access cover to the vitreous shell by silica gel.
Push to Flush.
Screw
Cap
Grommet
COMPLETE THE INSTALLATION
1303729-T01-G
14
Kohler Co.
Summary of Contents for K-77780T-0
