Operating Instructions (cont.)
With the whirlpool operating, rotate the outer ring until the neckjet icon is flashing. Press
″
OK
″
to
activate the neckjets. The neckjet pulsing action will start at medium speed.
Adjust the neckjet pulsing action by pressing either the up or down icon.
To adjust the different modes while the neckjets are operating, rotate the outer ring until the desired
mode is flashing and press
″
OK.
″
Press
″
OK
″
while the neckjet mode is flashing to turn off the neckjets.
Press the Power On/Off icon a second time to turn the whirlpool off.
Neckjet and Backjet Operation (if equipped)
Rotate the outer ring until the backjet mode is flashing and press
″
OK.
″
The backjet pulsing action
will start at medium speed. The backjets pulse from the bottom of the whirlpool toward the top,
with water flow and pulse action occurring from two backjets at a time.
NOTE:
If the water level falls below the water level sensors, the backjets will stop. The backjet icon and
indicator bar on the user keypad will flash. The backjets will automatically restart when the water level
covers the sensors.
To adjust the backjet pulsing action use the up and down icons.
To adjust the flow volume to the backjets, rotate the outer ring to the Flexjet mode, press
″
OK,
″
and
press the up or down icons. (This also adjusts the flow to all modes.)
NOTE:
To activate or deactivate different modes while the neckjets and/or backjets are operating, rotate
the outer ring until the desired mode is flashing and press
″
OK.
″
(Example: To turn the heater off, rotate
the ring until the heater icon is flashing and press
″
OK.
″
)
Press
″
OK
″
while the neckjet mode is flashing to turn off the neckjets.
Press
″
OK
″
while the backjet mode is flashing to turn off the backjets.
Effervescence Operation (if Equipped)
With the whirlpool operating, rotate the outer ring until the effervescence icon is flashing. Press
″
OK
″
to activate the effervescence ports. The effervescence action will start at the flow volume last
set in the Flexjet flow mode.
Adjust the flow volume by pressing either the up or down icon.
NOTE:
Flexjet mode, backjets and neckjets will automatically turn off when the effervescence mode is
activated. Chromatherapy may be used with this and all modes of operation.
Press
″
OK
″
while the effervescence mode is flashing to turn off the effervescence ports.
Chromatherapy Operation (if Equipped)
NOTE:
Chromatherapy may be used with all modes of operation as well as when the pump is not
operating.
Chromatherapy Cycle:
Rotate the outer ring to select this mode and press
″
OK
″
to activate. Press
″
OK
″
again to turn off the lights.
NOTE:
When this mode is activated, the chromatherapy lights will automatically and continuously cycle
through the eight colors; white, violet, indigo blue, aqua blue, green, yellow, orange and red. One cycle
through all eight colors takes approximately one minute.
Chromatherapy Specific Color Selection:
Rotate the outer ring to
″
Chromatherapy Specific Color
and press
″
OK
″
to activate. Press the up or down icons to change the desired color. Press
″
OK
″
while the chromatherapy mode is active to turn off the lights.
Remote Control
Kohler Co.
11
1199250-2-A
