1204153-X2-A
4
Kohler Co.
Tools
Site Requirements
Plus:
¨
Plumbers putty
¨
Wall coverings (if necessary)
¨
Gypsum cement (optional)
¨
Construction adhesive or silicone
(optional)
¨
Protective covering for bathtub
¨
Nails
¨
Conventional woodworking or
concrete installation tools and materials
¨
Drop cloth
NOTICE:
Unless otherwise specified, floor support under the bath must provide for a minimum of 390 kg/
square meter loading.
¨
Make sure the flooring offers adequate support for your bath, and verify that the subfloor is flat and level.
CAUTION:
Risk of product damage.
Do not support the bath by the rim.
CAUTION:
Risk of product damage.
Do not lift the bath with airjets by the air channels or blower
motor, or use the air channels or blower motor for structural support of the bath.
CAUTION:
Risk of product damage.
Do not support the bath by the rim.
¨
Your new bubble has been manufactured to the highest possible standards, it has been factory tested and
approved.
¨
When removing bath from protective carton .
DO NOT LIFT BATH BY PIPE WORK.
Inspect for any possible
damage that may have occurred in transit. Position a clean drop cloth or similar material in the bottom of the
bath to pretect the finish. Be careful not to scratch the surface of the bath.
IMPORTANT:
Bath must be installed level on all top edges.
Installation
Before Installing the Bath
¨
Unpack bath shell and skirt and check for any transit damage prior to installation.
¨
Position the bath shell in the desired location in the bathroom.
¨
Check that the plumbing can be connected to the bath when in the desired location.
A. Install the Bath
