Kohler Co.
5
1204153-X2-A
¨
The drain has been installed onto the bath before it leaves factory. Fill the bath with water before the bath
is securely positioned so as to check the connections for leaks.
¨
Ensure a seal on the bath drain and the floor drain.
NOTE:
Be careful not to damage the bottom of the bath and the subfloor.
C. Put the bath at desired position
¨
Adjust feet height.
¨
Adjust the four feet to 48 mm lower than the apron and keep the feet in the same plane.
B. Check Plumbing
CAUTION:
Risk of product damage.
Ensure a watertight seal on the bath drain.
Installation (Cont.)
¨
Up stand bathtub, slide feet to the bath fixed position, check all clips in the same direction; locate center lines
as drawing (according to the line on the ground, line on the bathtub rim by square).
¨
Ensure the adequate space for the bath sliding from the feet. Check and insure the clip direction to making the
bath slide in and out in the same way.
¨
Remove the bathtub; fasten the feet clip to the floor by using the screws attached in the package. Every clip
fastened by 2 screws in the diagonal.
¨
Adjust the nut on the feet, making the nut lower 2-3 mm than the clip.
¨
Readjust the feet height, making the feet lower 5 mm than the apron.
Screw Out
