3. Install the Spout
CAUTION: Risk of product damage.
Use care when installing
the spout assembly to prevent damage to the O-ring seal.
IMPORTANT!
Keep the spout supply tube clean above the finished
deck to avoid damage to the O-ring seal.
Loosen the setscrews in the sleeve.
Use a twisting motion to install the sleeve on the spout supply
tube until it contacts the deck or washer.
Align the sleeve with the setscrews offset from the center (not
facing directly forward or backward) of the supply tube.
Remove the setscrew from the back of the spout assembly.
Thread the collar all the way onto the spout assembly.
Slide the spout sleeve onto the spout assembly and thread the
escutcheon snug against the sleeve.
Apply a bead of plumbers putty or other sealant to the underside
of the escutcheon according to the manufacturer’s instructions.
Position the spout on the sleeve, and carefully press down until
the spout contacts the finished deck.
Align the spout as desired and tighten the setscrew.
Thread the escutcheon down until it contacts the deck.
Remove any excess putty or sealant.
Setscrew
Setscrew
Sleeve
Collar
Sleeve
Setscrew
Escutcheon
Apply
Plumbers
Putty.
O-Ring
Kohler Co.
5
106386-2-AB
