Bath Operation
A. Fill the Bath
NOTE:
Please read these steps carefully before you operate your bath. Troubleshoot any problems using the
“Troubleshooting” section.
Turn the drain controller counterclockwise to close the drain.
Fill the bath to a level above the top of the higher jet around 50 mm.
NOTE:
Massage function may fail to start if water level is too low.
CAUTION : Risk of product damage.
Ensure that the area around the blower motor is free of sawdust,
insulation, dirt, or other small loose debris. Such material could clog the pump motor ducts and reduce the
air flow through the pump motor.
B. Keypad and Operation
Power On/Off
Press the button “
”
on the user keypad to start the system and enter to standby mode. The red light is on.
Press the button “
”
again to stop the system.
LED On/Off
Press the button “
”
on the user keypad to turn on the LED light.
Press the button “
”
again to turn off the LED light.
Whirlpool Pump On/Off
Press the button “
”
on the user keypad to start the whirlpool pump. The red light is on, the back jets
are activated.
Press the button “
”
again to stop the whirlpool pump. The back jets are deactivated.
When the water level lowers than the setting value, the whirlpool pump automatic stops working, at the same
time
the red light of
the button “
”
is off
. When anytime the water level achieve the setting value, the red light
is on again and the pump start to work.
Blower Pump On/Off
Press the button “
”
on the user keypad to start the blower pump. The red light is on, the bottom jets
are activated.
Press the button “
”
again to stop the blower pump. The bottom jets are deactivated.
NOTE:
When any function button works, there is a “beep” indication sound.
Power On/Off Switch
LED On/Off
Whirlpool Pump On/Off
Blower Pump On/Off
1334405-EM2-A
8
Kohler Co.
