Test Run the Bath
Check all electrical connections.
Make sure all piping connections are secure.
Temporarily remove the plastic drop cloth or other protective sheeting from the bath.
Fill the bath to a level above the top of the higher jet around 50 mm.
Refer to “Bath Operation” to make sure that every function works well.
Operate the bath. Check all piping connections for leaks. Repair any leaks.
Stop the massage and drain water. Check the drain connections for leakage.
Return the plastic drop cloth or other protective sheeting to the bath.
NOTE:
Your spa has been factory tested and approved. It is the responsibility of the installer to test run the spa check
all the fittings for leaks and test the control functions.
NON OBSERVANCE WILL INVALIDATE FACTORY WARRANTY.
Complete Installation
Insert the top of the aprons into the enclosement.
Tighten the screws to secure the aprons to the bath, then fix the caps.
Seal the joints between the bath rim edge and the wall with silicone sealant.
Install the Removable Pillows
NOTE:
For best attachment to the bath surface, moisten the back surface of the pillows at the suction cup locations.
Clean the bath surface. Moisten the suction cups on the back side of the pillows. Position the pillows as
illustrated. Check to make sure that the pillows are attached firmly to the bath.
Detach the pillows by lifting them off the bath surface.
CAUTION : Risk of product damage.
Do not submerge the pillows underwater or use them as seat cushions.
Apply Silicone Sealant
Pillow Head
Pillow Head
Kohler Co.
9
1334405-EM2-A
