25
1306246-W2-D
Follow the steps below to pair the shower with a Bluetooth pump. If the shower has
been paired previously and is required to pair with a different pump, it is necessary
to unpair the shower first (see page 24).
If the shower has not been paired previously, the Status light will flash
blue
for a few seconds while the shower pairs. When the pairing
processes has completed successfully the shower will beep to indicate
that the shower and pump are ready for use, and the Start/Stop
light will change to
white
. This procedure could take up to 1 minute.
Note:
If the shower doesn’t pair check the correct parts are being used
and make sure the transformer is within range.
If the shower is already paired when power is applied the Start/Stop light will show
white
rather than showing a
flashing blue
Status indication. If an error code ‘B’ is
displayed (Start/Stop off with Status
flashing yellow
) on pressing the Start/Stop
button, the shower may not be paired correctly. Unpair the shower (see page 24)
and repeat the steps above.
Bluetooth Pairing
1 2 3 4 5 6 7
10 30 60
1 2
Make sure that the
BLE PUMP ENABLE
switch is set to
ON
.
Turn on the power to the pump. The
light will flash
red
every 4 seconds
indicating that it is not paired.
Press the start button and hold for
7 seconds, the light will flash
green
and
red
indicating that it has entered pairing
mode.
Note!
You have 120 seconds to pair the
shower.
Turn on power to the appliance using
the pull cord.
1
2
3
4
1 2 3 4 5 6 7
10 30 60
1 2
1 2 3 4 5 6 7
10 30 60
1 2
1 2 3 4 5 6 7
10 30 60
1 2
1
2
3
4
5
6
7
8
BEAB CARE MODE
OFF
ON
43 DEG C
45 DEG C
RESERVED 1
ECO
RESERVED 2
BLE PUMP ENABLE
WIRED PUMP MODE
5
x1
Summary of Contents for Mira Advance 8.7
Page 38: ...38 1306246 W2 D Notes ...
Page 39: ...39 1306246 W2 D Notes ...
