22
1383572-W2-A
Assemble the clamp bracket, hose
retaining ring, slide bar supports and caps
to the slide bar.
Make sure that the wall screws are flush
with the inside edge of the mounting
brackets. Fit the slide bar supports over the
mounting brackets, then adjust the slide
bar vertically ensuring an equal length of
slide bar protrudes from the top and bottom
mounting bracket (or flush with the end of
the slide bar for new installations).
Remove the slide bar assembly carefully,
preventing any further movement between
the slide bar and the slide bar supports.
Tighten the two slide bar clamping screws
no more than half a turn to secure the slide
bar supports to the slide bar.
Caution! Overtightening these screws
will cause damage.
Insert the wall plugs and fix the mounting
brackets and secure with the wall screws.
Note: Check for vertical alignment
before tightening. The mounting
brackets are slotted to aid this
alignment. Then fully tighten.
Slide Bar
Support (x2)
Clamp
Bracket
Hose
Retaining
Ring
Cap (x2)
Summary of Contents for Mira Elite SE
Page 35: ...35 1383572 W2 A Notes ...