-3-
·
·
Install the faucet and drain to the lavatory according to the
manufacture's instructions.
·
·
·
·
·
Carefully place the lavatory against the wall, so the
hanger bolts extend through the lavatory holes.
·
·
·
Level the lavatory.
Install the cap nuts and washers, and tighten until snug.
Do not
overtighten the cap nuts.Overtightening may cause
damage to the product.
Clean the lavatory top.
CAUTION: Risk of product damage.
·
·
Put the sealant around the back wall attached surface of
the lav evenly.
Apply Silicone sealant
along this face
Washer
Nut
Offset Nut
Fig.#3
3
·
·
10mm
(
)
,
65-
75mm
1.
2
3
2.
·
·
Drill two 10mm hanger bolt holes at the marks on the wall.
The nylon anchors is needed for concrete wall (supplied).
Mount hanger bolts to the wall so approximately 65-75mm
of each bolt remains exposed.
1. Height dimensions marked in fig. 2 and fig. 3 could
be adjusted per your the vanity height or the actual
height of the console leg.
2. Other fastening devices of sufficient size and
strength may also be used.
NOTE:
Attachment
Bolt (x2)
Wall Plug
550mm
Waste
Outlet
Waste
630mm
805mm
80mm
291.5mm
Fig.#2
2
1269083-T01-B
