10.
Changing Nozzles on Spray Wand
The nozzles for the spray wand are stored in the
nozzle holder on the panel assembly. Colors on the
panel identify nozzle spray pattern.
DANGER!
Risk of fluid injection. Do not direct
discharge stream toward persons, unprotect
-
ed skin, eyes or any pets or animals. Serious
injury will occur.
WARNING!
Flying objects could cause risk of
serious injury. Do not attempt to change noz-
zles while pressure washer is running. Turn
engine off before changing nozzles.
1. Pull quick-connect
coupler (E) back and
insert nozzle (K).
2. Release quick-connect
coupler and twist nozzle
to make sure it is secure
in coupler.
WARNING!
Flying object could cause risk of
serious injury. Ensure nozzle is completely
inserted in quick connect socket and quick-
connect collar is fully engaged (forward)
before squeezing gun trigger.
Applying Chemicals & Solvents
Applying chemicals or cleaning solvents is a low
pressure operation.
NOTE:
Use only soaps and chemicals designed for
pressure washer use. Do not use bleach.
1. Ensure detergent siphon hose (F) is attached to
barbed fitting location near high pressure hose
connection of pump
as shown.
2. Place other end of siphon
hose (with filter on) into
container holding
chemical / cleaning
solution.
NOTE:
F
or every 7 litres of water pumped
1 litre of chemical/cleaning solution will be used.
3. Install the black low pressure nozzle into the
quick connect fitting of the spray wand and rotate
the Dial-N-Wash (M) to the MAX pressure setting
as shown in ‘How To Use Spray Wand’ on the
previous page.
NOTE:
To apply chemicals the black low pressure
nozzle must be installed and the Dial-N-Wash must
be in the MAX pressure setting as shown
in
‘How To
Use Spray Wand’ on the previous page.
4. After use of chemicals, place detergent siphon
hose into container of clean water and draw clean
water through chemical injection system to rinse
system thoroughly. If chemicals remain in the
pump, it could be damaged. Pumps damaged
due to chemical residue will not be covered under
warranty.
NOTE:
Chemicals and soaps will not siphon if the
black soap nozzle is not installed on the spray wand.
Starting the Pressure Washer
WARNING!
To reduce the risk of injury, read
the pressure washer instruction manual and
the engine instruction manual before starting
pressure washer.
DANGER!
Risk of fluid injection and lacera-
tion. When using the high pressure setting,
DO NOT allow the high pressure spray to
come in contact with unprotected skin, eyes,
or with any pets or animals. Serious injury will
occur.
Your washer operates at fluid pressures and veloci
-
ties high enough to penetrate human and animal
flesh, which could result in amputation or other
serious injury.
Leaks caused by loose fittings or worn or dam
-
aged hoses can result in injection injuries. DO NOT
7109782 PS3395 EuroQuip Manual.indd 10
4/4/2017 9:44:00 AM
