1242170-2A-A
2
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
SERVICE PARTS
OPERATING INSTRUCTIONS
INSTALLATION
**Color code must be specified when ordering
How to Clean the Nozzles
Any debris or mineral build-up may cause the flow stream to become distorted
or reduce the flowrate. To remove the debris or mineral build-up, run water
through the handspray, firmly press or rub your finger back and forth across
the rubber nozzles.
Flush both water supply for about one minute before the handspray is
installed.
Place the check valve(2) into the handspray(1) according to the drawing.
Note:
Keep
the O-ring of the check valve downward.
Install flow regulator(3) into the shower inlet if needed.
Note:
If working pressure is too low, regulator is not needed.
Put the screen washer(4) into the shower hose(5, not provided) connector.
Attach the handspray to shower hose.
Note:
Don’t over tighten.
Connect another end of shower hose to the water supply.
3
5
2
1
4
1030624
77420
1240266
