-2-
NOTES
·
·
·
·
·
·
·
·
·
·
Observe all local plumbing and building codes.
Shut off the water supply.
Seat post holes are on 140mm (5-1/2") centers.
51mm (2") passageway.
Water depth from the rim is 160mm
.
Ensure that the new drain has the correct roughing-in
dimension. This toilet has a 305mm/400mm roughing-in
dimension.
.
Closet flange must be 305mm/400mm on-center from wall.
Carefully inspect the new fixture for any sign of damage.
For new construction, refer to the dimensions in
for locating the shut-off valve.
(5-1/2")
Fixture dimensions are nominal and conform to tolerances
established by ASME Standards (A112.19.2-2018).
This product complies with GB 25502-2017. Water
Efficiency Grade 1.
See Fig. #1
Fig. #1
and Fig. #4
·
·
·
·
·
·
·
·
·
·
140mm
51mm
160mm
305mm/400mm(
1)
305mm/400mm
1
4
·
·
ASME
(A112.19.2-
2018)
GB 25502-2017
1
TOOLS AND MATERIALS REQUIRED (Not
supplied)
·
·
·
·
·
·
·
·
·
·
·
·
·
254mm (10") adjustable wrench
305mm (12") pipe wrench
Metal file (file cut)
Tape measure
Tubing cutter
Level
Hacksaw
Putty knife
Screwdriver
Toilet gasket (wax seal)
Toilet T-bolts (2), 8mm (5/16") diameter
Toilet supply shut-off valve, 10mm(3/8 ) recommended
Hose Pipe
"
If the existing toilet does not have a supply shut-off
valve below the tank, install one before installing the new
toilet.
The stop valve and wax ring are not supplied.
NOTICE:
·
·
·
·
·
·
·
·
·
·
·
·
·
254mm
305mm
8mm
T
2
10mm
WARNING: Risk of personal injury or product
damage
WARNING: Risk of external leakage
: Handle vitreous china products very carefully.
Vitreous china can break and chip if you overtighten
bolts and nuts.
. The fill valve
nut has been factory-tightened to design specifications.
If re-tightening is required, wrench tighten one turn
past finger tight .
1364890-T01-B
