Position the Whirlpool - Alcove Installations (cont.)
Verify that the whirlpool is level and resting on all supports.
Clean the whirlpool to reduce the risk of damaging the surface.
10. Position the Whirlpool - Drop-In/Island Installations
Install the drain and overflow assembly to the whirlpool according to the drain manufacturer’s
instructions. Do not connect the trap at this time.
Position the whirlpool in the recess.
Verify that the whirlpool is level and well supported by the floor.
If the whirlpool is not level or well supported, remove the whirlpool and place shims under the
whirlpool feet. Use metal, hardwood, or other durable material for the shims.
NOTE:
The maximum distance between shimmed feet is 22
″
(559 mm).
Position the whirlpool in the recess and retest for level. Repeat until the whirlpool is level.
Make sure there is a 1/16
″
(2 mm) gap between the deck and whirlpool rim.
1105582-2-F
14
Sterling
