1237458-T01-A
-3-
(
)
!
!
!
NOTE:
For Retrofit Installations
For New Installations
If a pre-existing waste pipe will be used and will result
in an acceptable rim height (refer to the rough-in dimensions),
follow the retrofit installation instructions.
Turn the water supply line off, remove the existing urinal,
then cap off the water supply line inside the wall.
Install waste pipe as necessary to conform to the
roughing-in dimensions.
Install adequate support framing for the hangers as
needed.
!
!
!
Fig.2
2
PREPARE THE SITE
PREPARE THE SITE
Drain Connection
Notice:
To ensure an effective flush performance,
strongly recommended inner diameter of
water supply (including water meter, valve, etc.)
is no less than 25mm, and supplied water
pressure (sensor inlet dynamic pressure) is
0.18MPa ~0.55MPa.
(
)
25mm
(
)
0.18MPa ~0.55MPa
A. Install hangers, L shape block and waste pipe
connector
Drill holes according to template. Install hangers, L shape
block and waste pipe connector. (Gasket of waste pipe
connector shall be soaked into water for 2 seconds to
lubricate.)
A.
L
L
(
)
INSTALLATION
Wall Hangers
Wall
Fig.3
3
Wall Hangers
Wall
Wall
35
Pre-installed waste
pipe connector
Insert the connector into the waste
pipe in the wall along this direction.
Move the gasket to front
of the pipe before
connecting to the urinal.
