Product Information
Applicable product:
Drop-in rim style, right-hand
pump
K-1160P-G
shown
Tile flange, right-hand pump
K-1160P-GF
not shown
Fixture*:
Bathing well
Basin area
bottom
52
″
(132.1 cm) x 38-3/4
″
(98.4 cm)
Basin area top
61
″
(154.9 cm) x 46-1/4
″
(117.5 cm)
Weight
118 lbs (53.6 kg)
To overflow
Water depth
15
″
(38.1 cm)
Capacity
96 gal (363.6 L)
* Approximate measurements for comparison only.
Blower motor:
Heater
V
Hz
A
1 hp
300 W
120
60
5
Minimum access panel pump/control:
20
″
(50.8 cm) W x 15
″
(38.1 cm) H
required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
120 V, 5 A, 60 Hz
Blower motor is supplied with a 24
″
(61 cm) grounding-type
plug-in cord.
Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum of
39 lbs/square foot (190 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the bath or
greater. Installations will vary.
This fixture conforms to CSA B45 and ANSI Standard Z124.1.2. All
dimensions are nominal.
27-1/2" (69.9 cm)
135˚
1-1/2" OD
135˚
3" (7.6 cm)
60" (152.4 cm)
35"
(88.9 cm)
35"
(88.9 cm)
60"
(152.4 cm)
29-1/8"
(74 cm)
43-3/4"
(111.1 cm)
Drop-In Rim Style
Cut-Out Detail
57-1/2"
(146.1 cm)
1-1/2"
(3.8 cm)
Drop-In Rim
Detail
2-7/8"
(7.3 cm)
63"
(160 cm)
19-1/2"
(49.5 cm)
2-7/8"
(7.3 cm)
21"
(53.3 cm)
1-1/4"
(3.2 cm)
Tile Flange
Detail
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
Recommended faucet area
29-1/8" (74 cm)
Blower/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min
1-1/8" (2.9 cm) from
the Floor to the
Bottom of the Drain
13-5/8"
(34.6 cm)
4-7/8"
(12.4 cm)
1076060-1-A
2
Kohler Co.
