4"
Notes
Required Electrical Service
Measure your actual product for rough-in details.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI). Outside North America,
this device may be known as a Residual Current Device (RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
240 V, 20 A, 50/60 Hz
Blower, Pump:
Technical Information
All product dimensions are nominal.
Kit is required for under-mount installations (sold
separately).
Drop-in, Under-mount
Installation:
Center
Drain location:
The pump base extends beyond the edge of the
rim. Modify the framing as needed.
43" x 25-5/8" (1093 mm x 651 mm)
Basin area, bottom:
55-9/16" x 28-3/8" (1411 mm x 720 mm)
Basin area, top:
IMPORTANT! Dry fit the drain assembly prior to
installing the bath. The bath cannot be installed
with all drain components attached.
160 lbs (72.6 kg)
Weight:
53.9 lbs/ft² (263.2 kg/m²)
Minimum floor load:
If installing a rim-mount faucet, make sure there
is no interference above or below the deck before
drilling any holes.
16-5/16" (415 mm)
Water depth:
72.017 gal (272.6 L)
Water capacity:
Drop-in, 1268438-7, required, included
Template:
Blower: 240 V, 3 A, 50/60 Hz
Pump: 240 V, 11 A, 50/60 Hz, 1500 W
Electrical component
rating:
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to
.
5-25-2019 09:00 - US/CA
Underscore
®
Oval
5' BubbleMassage
™
Whirlpool Bath
K-5714-XH2G
