background image

-2-

Install the Basin

Note!

The lavatory tops must be installed on a cabinet or

matching metal stand (refer to Installation and User Guide
packed with the cabinet or stand for installation details).

Recommend Kohler metal square leg or Kohler bathroom
furniture for support or decoration.

!

(

)

!

·

76mm

·

Rough-in the supplies and the drain piping.

The supply stop handles cannot extend more than

76mm from the finish wall when in the open position.

NOTE:

·

·

10mm

(

)

65-

75mm

1.

2

3

2.

·

·

Drill two 10mm hanger bolt holes at the marks on the wall.
The nylon anchors is needed for concrete wall (supplied).
Mount hanger bolts to the wall so approximately 65-75mm
of each bolt remains exposed.

1. Height dimensions marked in fig. 2 and fig. 3 could

be adjusted per your the vanity height or the actual
height of the console leg.

2. Other fastening devices of sufficient size and

strength may also be used.

NOTE:

K-15095T

Fig.#1

1

Attachment
Bolt (x2)

Wall Plug

550mm

Waste
Outlet

Waste

630mm

805mm

80mm

769mm

Fig.#2

2

125

165

805

70

35

205

45

380

700

130

454

540

URBANITY 1100mm Vanity
K-15096T

1100mm

K-15096T

1130444-T01-A

Summary of Contents for URBANITY 15096T

Page 1: ... time of publication Kohler China reserves the right to make changes in product characteristics packaging or availability at any time without notice Make sure that the wall and floor are square and plumb to ensure proper installation IMPORTANT ORDERING INFORMATION URBANITY 800mm Vanity K 15095T URBANITY 1100mm Vanity K 15096T 800mm K 15095T 1100mm K 15096T 528137 REQUIRED MATERIALS NOT SUPPLIED TO...

Page 2: ...10mm 65 75mm 1 2 3 2 Drill two 10mm hanger bolt holes at the marks on the wall The nylon anchors is needed for concrete wall supplied Mount hanger bolts to the wall so approximately 65 75mm of each bolt remains exposed 1 Height dimensions marked in fig 2 and fig 3 could be adjusted per your the vanity height or the actual height of the console leg 2 Other fastening devices of sufficient size and s...

Page 3: ...through the lavatory holes Level the lavatory Install the cap nuts and washers and tighten until snug Do not overtighten the cap nuts Overtightening may cause damage to the product Clean the lavatory top CAUTION Risk of product damage Put the sealant around the back wall attached surface of the lav evenly Fig 3 3 Apply Silicone sealant along this face Washer Nut Offset Nut Fig 4 4 URBANITY 800mm V...

Page 4: ...ATION IMPORTANT CONSUMER INFORMATION CARE AND CLEANING To keep your lavatory looking new make sure you rinse it out thoroughly after each use on this product as they will scratch and ruin the surface Stubborn stains paint or tar can be removed with turpentine or paint thinner DO NOT USE ABRASIVES Caution Risk of product damage Many cleaners contain abrasive and chemical substances and should not b...

Reviews: