-5-
COMPLETE THE INSTALLATION
COMPLETE THE INSTALLATION
Cast Iron Surfaces
CAUTION:
When cleaning up after installation, do not use abrasive
cleaners, as they may scratch and dull the bath
surface. Use warm water and a liquid, non-abrasive
detergent to clean the surface.
Do not allow cleaners containing
petroleum distillates to remain in contact with the
surfacer long periods of time.
Remove stubborn stains, paint, or tar with turpentine or
paint thinner.
Remove plaster by scraping with a wood edge. Do not
use metal scrapers, wire brushes, or other metal tools.
You can use a powder-type detergent on a damp cloth
to provide mild abrasive action to any residual plaster.
IMPORTANT CONSUMER INFORMATION
IMPORTANT CONSUMER INFORMATION
Safeguard
ASME/ANSI
A112.19.1M
pH
3
8
(
)
!
!
!
The Safeguard slip resistant surface on this bathtub
meets or exceeds the requirements of ASME/ANSI for
A112.19.1M slip resistance.
Improper maintenance or cleansers may
permanently remove the slip resistant surface on
Kohler bathtubs.
All housekeeping and maintenance
employees must be trained in the proper cleaning of
Kohler bathtubs. Post a copy of this notice in a readily-
visible location.
use steel wool, wire brushes, metal scrapers
or abrasive sponge pads to clean a Kohler bath tub.
use buffing machines on the slip resistant
surface.
use high alkaline or strong acid cleansers.
use abrasive cleansers.
Use only non-abrasive cleansers and a soft nylon
brush to clean the slip resistant surface.
When using commercial cleansers, use cleansers
with a pH of between three and eight.
Follow cleanser manufacturer instructions very
carefully.
DANGER!!
NOTICE:
DO NOT
DO NOT
DO NOT
DO NOT
!
!
!
INSTALL THE PLUMBING
INSTALL THE PLUMBING
2.
3.
2. Open the hot and cold water supplies and check all
connections for leaks.
3. Run water into the bath and check the drain
connections for leaks.
1.
K-20608T/K-20609T/K-99314T
!
1.
!
Install the plumbing
Refer to the installation instructions of K-20608T/K-
20609T/K-99314T.
1315528-T01-C
