Product Information
Applicable product:
Drop-in rim style
K-1112-G
shown
Drop-in, 4-side integral flange
K-1112-GF
not shown
Drop-in cutout dimensions:
58-1/2
″
(148.6 cm) x 40-1/2 (102.9 cm)
Fixture*:
Bathing well
Basin area
bottom
43
″
(109.2 cm) x 24-5/8
″
(62.5 cm)
Basin area top
53-1/2
″
(135.9 cm) x 32-1/8
″
(81.6 cm)
Weight
110 lbs (50 kg)
To overflow
Water depth
15
″
(38.1 cm)
Capacity
57 gal (215.9 L)
* Approximate measurements for comparison only.
Blower motor:
Heater
V
Hz
A
1 Hp
300 W
120
60
5
Minimum access panel/pump control:
20
″
(50.8 cm) W x 15
″
(38.1 cm) H
required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
120 V, 5 A, 60 Hz
Blower motor is supplied with a 24
″
(61 cm) grounding-type
plug-in cord.
Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum of
35 lbs/square foot (171 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
This fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
Recommended faucet area
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
1-1/2"
(3.8 cm)
Drop-In Rim
Detail
1-1/4"
(3.2 cm)
Tile Flange
Detail
1-1/2" OD
42" (106.7 cm)
19-1/2"
(49.5 cm)
1-1/2"
(3.8 cm)
3-1/8"
(7.9 cm)
3-1/2"
(8.9 cm)
10-13/16"
(27.5 cm)
60" (152.4 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
21"
(53.3 cm)
1" (2.5 cm) from
the Floor to the
Bottom of the Drain
Blower/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min
1076046-1-A
2
Kohler Co.
