AVV-711 Quick Book
21
·
Load collected readings
To delete currently selected reading
To insert new reading. Note: you must
move to last stored reading first to make
this option available
To “snap”(store) current values;
or to replace already stored
reading(confirmation dialog appears)
To navigate through readings
To advance to measure misalign step. All
collect conditions must be satisfied to allow
this.
Call popup menu
To activate/disable auto sweep mode. Auto
sweep mode can be activated only at
beginning of collect or after start from
scratch option call(must be no stored
readings in other words). Manual input and
manual angle must both be deselected too.
States and signs in this screen
[C]
Blinking amber “C” means that no data from transducer(s) currently accepted.
Usually, awaiting connection state.
[R]
Blinking red “R” means you currently view already stored reading. You can replace or
delete it.
If this sign is not present than you currently view “active”(not stored) reading,
therefore you can store it by press
Cursor absence and blinking red border over beam position box means no laser or
no transducer data error occurs
