AVV-711 Quick Book
24
5.3.1 TO SETUP READINGS DATA OFFSET (EXTEND Y VALUES RANGE)
To setup readings data offset (extend Y values range) press
Cautions in this screen
Shortcuts in this screen
Do not turn shafts while adjust
transducers, be especially careful while
perform adjusting transducers!
To apply changes
Tasks in this screen
To cancel and exit. Be careful cancel should
not be used if transducers adjustment were
performed
·
Setup readings data offset for extend
target range
Target range extension can be in two different conditions: first when beam(s) already out of target(s), or
second when beams still within target(s).
SETUP READINGS DATA OFFSET W HEN BEAM(S) ALREADY OUT OF
TARGET(S)
In this case shafts should be carefully turned back until beam(s) reach target(s)
do not touch transducers.
see figure beneath.
Turn shafts back slowly and carefully until beams reaches targets, device will show you prompt for next
step. Wait until yellow ‘get ready’ counter disappears and ‘Press ‘START’ to continue’ prompt appears.
