AVV-711 Quick Book
29
The adjustment values of the position of the feet F1 and F2 of the machine (M) in the horizontal plane
indicate the value of horizontal shift. The positive values mean that the feet must be pushed, the negative
values – the feet must be pulled.
The adjustment values of the position of the front feet F1 and F2 of the machine (M) in the vertical plane
indicate the value of vertical shift. The positive values mean that the feet must be lifted, the negative
values – the feet must be lower.
Single coordinate(Y) live alignment procedure
Horizontal live alignment
To start horizontal live alignment shafts should be in 9 or 3 o’clock position.
If you need to turn shaft press
to freeze. Turn shafts to desired position and press
to thaw. Do
not forget enter manual angle if use manual angle selected. After some averaging time desired plane
should become enabled for live update(blinking green checkbox appears at plane header). Loosen
moveable machine feet and start adjust the feet correction values (add or remove shims)
Vertical live alignment
To start vertical live alignment shafts should be in 6 or 12 o’clock position.
Do shafts rotation as
described in horizontal live alignment section
. Plane 6-12 should become enabled
for live update. Adjust the machine horizontal movement at feet (push or pull using jacking bolt if any )
according to live horizontal correction reading.
Biaxial (Y,X) live alignment procedure
Biaxial live alignment procedure mostly the same as the single coordinate procedure except that there no
need to turn shafts in to predefined positions and no need to turn shafts when change from horizontal to
vertical alignment and vise versa, but highly recommended turn shaft close to 45 evenly degrees(45-135-
225-315) for equalize measurement errors.
Shafts rotation during biaxial aligning is strictly prohibited!
CONTINUE WORK AFTER THE TRANSDUCERS POSITION CHANGED
Before continue work after the transducers position changed it is necessary to take two initial position
measurement points. If this happened notification message will appear at beginning of continue work.
Turn shafts to the first initial position, use hints on display. Do not forget enter angle manually if need
When shafts turned to acceptable positions AVV-711 system will switch to next step automatically after
the settling time of 15 sec. If shafts already settled you can reduce this time by press
