AVV-711 Quick Book
68
13. BORES CENTERLINE PROGRAM
SHORT EXPLANATION
Bores centerline program is used for straightness measurement of bores. Bearing journals when the
diameters vary can be measured as well as the machine stator or other not smooth objects. True
multipoint feature allows measure of up to 36 points at any angles for each bore. Number of points can
vary from bore to bore as well as the angles can vary too. Vertical objects can be measured too(switch to
manual angle input required). Each object with bore for measurement (bear, stator, etc) referenced as
“plane”.
PERFORM BORES CENTERLINE ALIGNMENT
To start program select “Bores centerline” from main menu and press
Main screen of the program appeared.
13.1 MAIN SCREEN OF THE PROGRAM (CONFIGURE PLANES AND CHANGE
PARAMETERS)
Cautions in this screen
Shortcuts in this screen
All required dimensions should be
properly entered(but you can edit them
later if need, measure data will not
affected)
To start new task
Tasks in this screen
To enter number of planes(bores) to
measure
·
Create/modify/overview bores chain
·
Setup
parameters
·
Enter
dimensions
·
Start
measurement
·
View misalignment results(available when
all measurements taken)
To set or clear all distances equal
To enter current distance
To enter bore diameter (optional). When
only three points of measurement used,
entering bore diameter will increase result
